1. Preparation
Do a good job of the top or wall shape that needs to be made of stainless steel lines, customize the color and size of stainless steel according to the drawings, and the size can be determined according to the doors and windows that need to be made, and can be measured with tools.
2. Unloading
Cut off the size and number of stainless steel according to the drawing size, do the diagonal treatment of stainless steel according to the shape, and try to use professional processing tools, such as chamfers, when processing.
3. Prepare a piece of gypsum board and cut the plasterboard with the same size as the inner diameter according to the inner diameter size of the stainless steel line. Cut into 100-150mm size small gypsum slats, small gypsum slats need to be placed on one side to prepare after they are ready, plasterboard cut strips, there are safety risks, let professionals operate.
4. Glue and fix the gypsum slats just prepared in the stainless steel lines, and the selected stainless steel nails must choose the appropriate length, too long and too short will cause the gypsum slats to not be fixed.
5. The next thing you need to do is sanding, and then glue the back of the plasterboard slat. When using back glue, a solid glue with relatively large viscosity should be used.
6. After fixing, install it on the top surface or wall modeling. When installing, you need to pay attention to the tight treatment of the seams at the opposite corners of the figure-eight, and when treating the seams, a better way should be to use a hair dryer to dry them, which is conducive to the solidification of the glue.
7. After the installation is completed, after the glue dries naturally, remove the stainless steel line skin, the newly made stainless steel bar appearance is very important to maintain ventilation and ventilation because of the role of glue.
